日照亚太森博浆纸项目涂装施工程序.doc

Paint Application Procedure for Rizhao PL-12 pulppaper Project (Highly Corrosive Area) 日照亚太森博浆纸项目涂装施工程序 Scope 概述 This application procedure covers the requirements and instructions of paint system of Rizhao PL-12 Project. For More information and Details of involved Paint products, please consults Technical Service Department of Akzo Nobel Protective Coatings. 本文是日照亚太森博纸浆项目的油漆涂装的要求和施工指导。更详细的信息和有关产品内容请咨询阿克苏诺贝尔防护涂料技术服务部门。 Abbreviations and Standards References 缩写和标准引用 Abbreviations 缩写 DFT Dry Film Thickness 干膜厚度 WFT Wet Film Thickness 湿膜厚度 SSPC Steel Structures Painting Council 钢结构涂装委员会 ISO International Standard Organization 国际标准化组织 NACE National Association of Corrosion Engineer 国家腐蚀工程师协会 Standards References 引用标准 ISO 8501-1 Preparation of steel substrates before application of paints and related products - Visual assessment of surface cleanliness. 表面清洁度目测法评估 ISO 8502-3 Preparation of steel substrates before application of paints and related products - Test for the assessment of surface cleanliness - Assessment of dust on steel surfaces prepared for painting, pressure sensitive tape method. 表面清洁度测试评估－准备涂漆的钢材表面灰尘评估－压敏胶带法 ISO 8503 Preparation of steel substrates before application of paints and related products - Surface roughness characteristics of blast cleaned substrates. 喷射清理表面粗糙度特征 SSPC SP1 Solvent Cleaning 溶剂清洗 SSPC SP10 Near White Blast Cleaning 近白级喷射清理 SSPC PA 2 Measurement of Dry Film Thickness 干膜厚度测量方法 ISO 2808 Measurements of Film Thickness 漆膜厚度测量法 ISO 4628 Paints and varnishes - Pull-off test for adhesion 附着力拉开测试法 Paint specification 涂料配套方案 Surface preparation 表面处理 ISO 8501-1 (1988) - Sa2?, with surface profile Rz 40 -75microns. 钢材表面要喷砂处理至ISO 8501（1988）Sa 2 ? ，表面粗糙度达到Rz40－75微米。 Application 施工方法 Airless spraying is recommended Brushing for stripe coating or small area touch-up only. 推荐使用高压无气喷涂, 刷涂仅用于预涂和小面积修补. Specification 配套方案 C