GPS计算培训（GPS training）.docVIP

GPS计算培训（GPS training） Home page | log | message board | album The log Go to the next list of return logs China haida GPS training manual Comment (0) | browsing (104) click to view the original text Static control measurement [GPS network level] According to the global positioning system measurement standard issued in 1992, the GPS baseline vector network is divided into five levels: A, B, C, D and E. The figure below shows the relevant content of the GPS network level in the global positioning system measurement specification. The precision index of GPS network is usually expressed by the distance error between adjacent points in the network. Its specific form is: Among them, In the distance between adjacent points in the network (mm); : fixed error (mm); : proportional error (PPM [8]); The distance between adjacent points (km). For different levels of GPS network, the following precision requirements are: Measurement category Fixed error (mm) Proportional error (PPM) Adjacent point distance (km) a. 5 or less 0.1 or less 100 ~ 2000 B 8 or less 1 or less 15-250 C 10 or less 5 or less 5 ~ 40 D 10 or less 10 or less 2 ~ 15 E 10 or less 20 or less 1 ~ 10 The a-level network is generally the regional or national framework network, regional dynamic network; Class B network for national geodesic or local framework; The c-level network is the local control network and the project control network; D level network for engineering control network; E - class network for mapping. [GPS network form] 1. Point connection Features: the advantages of the point-connected observation mode are high efficiency and rapid graphics expansion; Its disadvantage is that the graphics strength is low, and if the join point is a problem, it will affect the synchronous graph in the back. 2. Edge connection Features: the method of side - line observation has better graphics strength and higher operating efficiency. [principle of selection] 1. Open site (15 degrees above) 2. No electromagnetic inter