杠杆课程设计（Leverage course design）.docVIP

杠杆课程设计（Leverage course design） Examples of course design of mechanical manufacturing basis A preface, The basic course design of mechanical manufacturing is carried out after we have completed all the basic courses, technical basic courses and most specialized courses. This is an in-depth and comprehensive review of the courses before graduation, and it is also a theoretical and practical training. Therefore, it plays an important role in the students college study in four years. The analysis of the parts 1. The role of parts The parts given in the title are the universal joint sliding fork on the transmission shaft of the jiefang automobile chassis, which is located at the end of the driving shaft. The main function is to transfer torque to make the car get the impetus to move forward; Second, when the rear axle spring of the vehicle is in a different state, it can adjust the length and position of the transmission shaft by this part. Two fork head of spare parts, there are two Φ 39 mm hole, used to install the needle bearing and connected with the spider, ACTS as universal coupling. Within 65 mm cylindrical parts Φ for spline Φ 50 mm to match the end of the spline shaft, used to transfer power. 2. Process analysis of parts There are two machining surfaces of universal joint sliding fork, and there is a certain position requirement between them. Here is the following: (1) Φ 39 mm hole centered processing surface This includes a set of processing surface: two Φ 39 mm hole and chamfering, size is 118 mm with two holes Φ 39 mm in the vertical plane, and four M8 screw holes on the plane. Among them, the main processing surface for Φ 39 mm two holes. (2) spline Φ 50 mm centered processing surface This includes: a set of processing surface Φ 50 mm 16 teeth spline hole, Φ 55 mm ladder hole, and Φ 65 mm of the surface of the cylindrical surface and M60X16mm external thread. There is a certain position between the two processing surfaces, mainly: 1) Φ 50 mm spline and Φ 39