注塑机操作中应注意的几点（A few points should be noted in the injection molding machine operation）.docVIP

注塑机操作中应注意的几点（A few points should be noted in the injection molding machine operation） In the procedure of injection molding machine, conscientiously implement the production operation procedure of injection molding machine production equipment and the need of individual job security, is necessary to ensure the quality of DE kumar injection molding machine, molding products. The procedures required in the operation are the best maintenance of the production equipment. Therefore, the operator should bear in mind the production operation procedure of the injection molding machine before taking the post, and the procedures and requirements stipulated in the operation procedure must be carried out carefully in the work. 1. Preparation before production To clean up the environment of production equipment and not to store any items that are not related to production. The production equipment shall have a clean and hygienic work, and the parts shall not be greasy or dirty. The joint of the injection molding machine and the slide guide of the injection seat must be clean as new, then coated with oil. The production and use tools are clean and hygienic and neatly arranged. Check all parts of the safety protection device is in good condition. In case of emergency stop, all kinds of safety and alarm devices will be able to work correctly. The safety door should be sliding flexibly, the position of the opening and closing should be in proper contact with the limit switch. Check all parts of screws, nuts are loose, should ensure the strong bond between the parts. Check all control switches, buttons and handles for damage, operation should be flexible, each switch should be in disconnect position. Check all circuit connections and ground wire for loose phenomenon. To inspect the amount of oil in the oil tank in the hydraulic transmission system, and the liquid level shall be in the high position of the oil mark; To inspect the quality of the hydraulic oil, clean up the non-impuri