热镀锌相关（Hot-dip galvanizing）.docVIP

热镀锌相关（Hot-dip galvanizing） The opportunity of centrifugal dumping is the solution that you seek to improve the surface quality of hot-dip galvanized, reduce the consumption of zinc, reduce the fuel cost, and extend the life of the zinc pot. At present, the hot galvanizing manufacturers generally have the surface blackening and lack of luster, the surface of the workpiece is not recycled, the zinc is not recycled, and the zinc consumption is not high enough. What is more, restricted by backward over after zinc plating process, the temperature of the hot galvanizing must be conducted under the condition of 530 ℃ or higher, zinc pot life only 7 to 10 days, we have to replace or repair; Attached at the same time, the zinc layer too thick, the screw for the reserved negative allowance before plating and thread after plating processing, cant guarantee the thread from the technology processing and standardization, and destroyed the integrity of the coating, seriously affected the economic benefits of hot galvanizing factory, a lot of galvanized factory this nerve-racking, but your company doesnt have to become a member of them KND to provide you with a set of special requirements for hot galvanizing technology is used to solve the problem of over after zinc plating processing patent product - centrifugal jilt zinc machine, its structure is simple, clever, centrifugal and hit close 2 for one, has the advantage of centrifugal jilt form zinc machine will be more complete automatic control in 1.5 seconds, make the surface excess zinc layer in liquid were dumped before solidification, occurring in the process of men more than zinc without special treatment, can be used in zinc pot again repeated, saving more than 15% zinc consumption, and surface coating uniformity, smooth level off, coating thickness in the thread tolerance range, greatly facilitate filling processing, dispense with the galvanizing on flat mat before plating to leave negative allowance and thread after plating