焊装夹具 包边机工艺设计制造规范（Design and manufacturing specifications of welders welder machine）.docVIP

焊装夹具 包边机工艺设计制造规范（Design and manufacturing specifications of welders welder machine） Design and manufacturing specifications for welder welders welder welders (1) nok automobile equipment manufacturing co., LTD. Is concerned about the welding jig, the working position and the edge of the workshop, and the mechanical standard of the package is only for reference by the relevant leaders of Great Wall automobile co., LTD. Design specification of nok welding fixture design process set meter In accordance with the 1. Computer data of welding jig and edge rolling parts; 2. Location map of solder; 3. Parts drawing, sub-assembly drawing, assembly drawing; 4. Welding process document, and the owner of the edge process document set meter to 1. Welding fixture design of general drawing: General layout on: jig dimensions, high operation and grid line (with the car coordinate line) unified benchmark, coordinates, coordinates the benchmark holes, the installation position of the main parts, the cylinder position, in the diagram according to the real situation of automobile product parts in automobile vehicle coordinates established; Coordinate system based on fixture. Place the product on the fixture and draw it with a thin double dot. The position of the solder is indicated, the coordinates of the solder points are noticed in the design, and the position of the full welder work space is provided for the welding. Use a double dot to indicate the shape of the electrode holder. 2. Fixture block design: After processing, the surface of the surface is black or spray paint, the positioning surface of the regulation block is relative to the reference mark, and the supporting direction of the regulation block is equipped with the adjustment gasket. The length of clearance adjustment film shall be as 50 and 65mm as possible, and the normal range shall be no more than 80mm, except for special circumstances. All clearance adjustment plates are 5mm thickness and the positioning pin is: 2mm x