215电动机及其附属设备安装工工艺（Electric motor and its ancillary equipment installation process）.docVIP

215电动机及其附属设备安装工工艺（Electric motor and its ancillary equipment installation process） 1 scope This technological standard is applicable to the installation of stationary, straight and synchronous motor and its ancillary equipment for general industrial and civil construction electrical installations. 2 construction preparation 2.1 requirements of equipment and materials: 2.1.1 motor nameplate, indicate the factory name, production date, motor model, capacity, frequency, voltage, current, wiring method, rotational speed, temperature, working methods, relevant technical data such as the insulation class. 2.1.2 the capacity, specification and model of the motor must conform to the design requirements. The accessories and spare parts are complete, and there are factory certificate and relevant technical documents. 2.1.3 motor control, protection and starting the accessory equipment, should be matched with the motor, and a nameplate, indicate the factory name, date of production, specifications, models, and the factory certification and other relevant technical data. 2.1.4 all specifications shall conform to the design requirements and no obvious corrosion of steel sections. And there is material proof. 2.1.5 bolts: galvanized bolts shall be used in addition to the motor stabilisation bolts, and the corresponding galvanized nut plain washers and spring pads shall be fitted. 2.1.6 other materials: insulation belt, electric welding rod, anti-rust paint, mixing paint, transformer oil, grease and other products should have the product certificate. 2.2 main machine tools: Chain hoist and gantry, rope buckle, bench drill, grinding wheel, hand electric drill, coupling extractor, vise, hydraulic pliers, wrenches, hammer, flat file, hammer, steel ruler, round steel wire plate, electric welding machine, welding tools, feeler, spirit level, tachometer, shaking table, multimeter, clamp ampere meter, test pencil, try the bell, electronic thermometer. 2.3 working conditions: 2.3.1 constr