DRAC使用讲义（DRAC USES handouts）.docVIP

DRAC使用讲义（DRAC USES handouts） DRAC 5 USES handouts 1. DRAC 5 is dedicated to providing remote management functions, crash system recovery and power control functions for Dell system, with its own CPU, memory and system. 2. DRAC 5 May be pre-installed in the system or provided separately in the suite. 3, the DRAC 5 is a set of B/S structure, do not need to install any software can perform common tasks, extend the installation on the server install managed system (capture collapse last screen desktop), client Management station, in the server installation CD. 4. Configure the DRAC 5 properties, network Settings, and users - you can configure common programs, web-based interfaces, or RACADM using remote access 5, you can add and control DRAC 5 user privileges for existing users in Active Directory software The configuration system USES DRAC 5 To configure the system to use DRAC 5, use Dell? Remote Access configuration utility To run the Dell Remote Access configuration utility: Open or restart the system. Press Ctrl E . Use the lower arrow keys, and the high brightness shows NIC Selection. NIC choice: Dedicated - select this option to enable Remote Access devices to use a private network interface on Remote Access Controller (RAC). This interface is not Shared with the host operating system and will route administrative traffic to a separate physical network, which can be separated from the application communication. This option is available only when a DRAC card is installed on the system. Shared - select this option to share the network interface with the host operating system. When the host operating system is configured for the NIC group, the remote access device network interface will have full functionality. Remote access devices receive data through NIC 1 and NIC 2, but only send data through NIC 1. If the NIC 1 fails, the remote access device will not be accessible. Failover - select this option to share the network interface with the host operating system. W