arm优化（Arm optimization）.docVIP

arm优化（Arm optimization） data type The local variables stored in registers (especially the loop variables) should use the 32 bit data type int (=long) whenever possible, and the 8 bit variable does not save any space and time; Even if you transfer a 8 bit data, the function parameter and return value will be more efficient with a 32 bit class command; To increase the address by pointer, we dont need to increase the address by the next table. A=data[i++] is better than a=* (data++); Division operations are faster using unsigned numbers; Arrays and global variables stored in memory, using small size data types as much as possible; Short arrays avoid using array base address offsets, because the LDRH command does not support offset addressing; Explicit conversions are used when memory variables and register variables are assigned to each other, while other types of unnecessary conversions are avoided; Cyclic structure The cycle count reduction ratio counting loop termination conditions better, try to write I! = 0; loop variable initial value is variable and is not equal to 0 of the cases with DO-WHILE cycle better (termination condition after); If the loop body is too simple, such as less than 4 cycles, you can expand the loop body (repeat several rounds of loop body code) so that the loop body code is not as long as the cycle itself; Try to limit the internal loop of the function, with no more than 12 local variables, so that the compiler can assign them to the ARM register; function call Try to limit the parameters of the function to no more than 4. Several related parameters can be organized into a single structure; Place smaller, modulated functions and calling functions in a file, first defined, and then called; Important functions that have greater impact on performance can be inline using _inline; pointer aliasing Create a new local variable to hold an expression that contains memory access, so that you can guarantee only one value for this expression; for exampl