D型卧式多级离心泵安装使用说明书（D type horizontal multi-stage centrifugal pump installation instructions）.docVIP

D型卧式多级离心泵安装使用说明书（D type horizontal multi-stage centrifugal pump installation instructions） D horizontal multi-stage centrifugal pump installation instructions Changsha Zhongda water pump Industrial Co., Ltd. Changsha Zhongda water pump Industrial Co., Ltd. I. overview D pump is multistage, segmental centrifugal clean water pump, suitable for mines, factories and urban water supply and drainage. For conveying without solid particles and abrasives. Free water containing suspended solids or other liquids similar to water in physical and chemical properties. The transported liquid temperature is between -20 and ~80 degrees centigrade. Two, model description 1) 150 cases of 150D30X5 - suction diameter of the pump (mm) D multistage centrifugal pump segmental 30 single stage head for 30m 5 - pump stage 5 2) cases of D 280-43X5 D, multistage segmental centrifugal water pump 280, the pump flow rate (m3/h) 43 - single head for the 43M 5 series pump 5 Three. Structure description 1, pump shell pump shell part mainly by bearings, front section, middle section, back section, guide blade and so on with bolt to connect the whole, the front suction inlet line is horizontal line, the rear section spit the center line and horizontal vertical. 2, the rotor part of the rotor is mainly composed of bearings and the impeller installed on the shaft, shaft sleeve, balance plate and other components. The shaft parts are fastened by flat keys and sleeve nuts so as to be integrated with the shaft. The whole rotor is supported on the pump housing by both ends of the bearing, and the number of impellers in the rotor is determined according to the number of pumps. 3, the bearing part of the D pump bearings are sliding bearings and rolling bearings two, according to the model is different, are not subjected to axial force. The pump shall allow the rotor part to swim axially in the pump housing, and radial bearings shall not be used. The sealing surface between the sealing pump 4, pump the front, m