42VLAN中继协议探究.ppt

* Client也可以产生5分钟一次的summary advertisement * * * Notes: All switches in a VTP domain must run the same VTP version. The password entered with a domain name should be the same for all switches in the domain. If you configure a VTP password, the management domain will not function properly if you do not assign the management domain password to each switch in the domain. A VTP version 2-capable switch can operate in the same VTP domain as a switch running VTP version 1, provided version 2 is disabled on the version 2-capable switch (version 2 is disabled by default). Do not enable VTP version 2 on a switch unless all of the switches in the same VTP domain are version 2-capable. When you enable version 2 on a switch, all of the version 2-capable switches in the domain must have version 2 enabled. If there is a version 1-only switch, it will not exchange VTP information with switches with version 2 enabled. If there are Token Ring networks in your environment, you must enable VTP version 2 for Token Ring VLAN switching to function properly. Enabling or disabling VTP pruning on a VTP server enables or disables VTP pruning for the entire management domain. In the lab, all the switches are set to VTP transparent mode. * Layer 2 of 2 Note: The two commands shown in the slide can also be combined into one command: vtp domain switchlab transparent * 240, 197, 102 * * * * Layer 2 of 2 Note: The Catalyst 1900,at the time of the beta, only supports ISL trunking. It does not support 802.1Q trunking. * * Note: In the ICND lab, all the switches and routers are in VLAN1. The core server and the core router are in multiple VLANs. Each workgroup PC is on an unique VLAN. * Layer 2 of 2 * Layer 2 of 2 Note: Type: Default is Ethernet (other types are FDDI and Token Ring). SAID: Is used for FDDI trunking. MTU: Default is 1500 for Ethernet VLAN. STP: The 1900 only supports 802.1d Spanning-Tree Protocol. It does not support DEC or IBM Spanning-Tree Protocol. Routers support all three Sp