砂轮粒度、砂轮转速对42CrMo 钢磨削淬硬层的影响.PDF

下半月出版 Material Heat Treatment 材料热处理技术 砂轮粒度 砂轮转速对42CrMo 钢磨削 淬硬层的影响 刘克铭, 马壮, 张连勇, 刘波 (辽宁工程技术大学 机械工程学院, 辽宁 阜新 123000) 摘 要院在MM7 132 平面 床上对正火态的42CrMo 钢进行了 削淬火试验 研究了砂轮粒度及砂轮转速对淬硬 层深度及组织的影响遥 结果表明院磨削深度在0.1 0.6 mm 变化时 砂轮粒度对淬硬层深度影响不明显 砂轮转速由 1500 r/min 增加至3000 r/min 过程中 削淬火的工艺稳定性得到提高遥 削淬火后 42CrMo 钢的完全淬硬区显微硬 度为510 850 HV 完全淬硬区由细小的板条 马氏体组成 过渡区由马氏体尧铁素体尧珠光体以及回火索氏体组织组成遥 关键词院粉末冶金法曰碳酸氢铵曰羟基磷灰石曰Ti-6Al-4V 曰力学性能曰孔隙率 中图分类号院TG 156.3 文献标识码院A 文章编号院 Effect of Wheel Granularity and Speed to 42CrMo on Grind-hardened Layer LIU Keming, MA Zhuang, ZHANG Lianyong, LIU Bo (Sc hool of Mec hanical Enginee ring, Liaoning Tec hnical Univ ers ity, Fuxin 123000, China) Abstract 院The grind hardening experiments were performed on the MM7132 plane grinder with the normalized 42CrMo steel. Effects of the granularity of grinding wheel and rotating speed of it on the depths of grind hardening layer and structure were studied. The results show that there is no obvious effect on the depth of the grind hardening layer when the grinding depth is changs from 0.1 mm to 0.6 mm. When the rotating speed of grinding wheel increases from 1500 r/min to 3000 r/min, the technological stability of grind hardening improves. The range of micro-hardness in the fully hardened region of 42CrMo steel is 510 HV 850 HV. The structures in the fully hardened region are composed by fine lath martensite and the