2126大直径现浇混凝土薄壁筒桩竖向承载力计算研究.pdfVIP

25 1 Vol.25 Supp.1 2006 2 Chinese Journal of Rock Mechanics and Engineering Feb .2006 ( 310027) 5 2 ICP TU 473.1 A 1000 6915(2006)1 3181 09 STUDY ON VERTICAL BEARING CAPACITY OF LARGE-DIAMETER CAST-IN-SITU THIN-WALL TUBULAR PILE ZHOU Jian (Institute of Geotechnical Engineering Zhejiang University Hangzhou Zhejiang310027China) Abstract Large-diameter cast-in-situ thin-wall tubular pile is a new kind of pile and has been put to wide use in the treatment of soft soil in expressway damembankmentand excavation due to its advantages of cost-saving fast constructionhigh quality and less environmental pollution. Usually the bearing capacity of pile is caused by end-bearing capacity and the frictional resistance between soil and pile. Hencehow to evaluate the outer and inner friction resistances is the key point. So far little progress has been achieved. Whether soil core should be taken into account and how to rectify the end-bearing capacity and friction resistance are still under consideration. This is the main reason that the results deduced from present methods are far away those from the measurement. Based on the load transfer mechanismfive methods from domestic and overseas researches have been analyzed and compared with two case studies. In all these methods ICP method turns out to be the best one and can be easily used. Its calculation result coincides with the measurement from static loading testwhich demonstrates that this method is worthy to be used in practice. Key words pile foundation engineering large-diameter cast-in-situ thin-wall tubular pile outer frictional resistance inner frictional resistance vertical bearing capacity