激光打印机故障（Laser printer fault）.docVIP

激光打印机故障（Laser printer fault） For laser printers, because of their working principle is basically similar, so many quality failure is also a variety of models can be common. Laser printer when using a certain number of years, that is, the output of a certain number of samples, the quality of its printing will decline, and some components in use to the limit, there will be defects in print quality. Some are because we are not familiar with the principle and performance of laser printer, so the operation will not be adjusted to the best state or is in the wrong state, as well as the use of materials do not meet the requirements, so that the output effect is poor, this is what we called the fault is not fault. It generally does not affect the printers normal work, but the print results are not satisfactory, and so on. Here are some print quality problems and solutions. Output all sheets of black paper Possible cause of failure: (1) if the laser is certainly good, the charging electrode may be shorted to the grid; (2) scanning drive circuit logic error; (3) the discharge of the drum assembly is not good; (4) the signal line is not connected. Inspection location and inspection method: (1) first replace the drum assembly, to see if the fault is gone, and if it shows that the toner cartridge components, the replacement of it. The appearance of the entire page is black, indicating that the laser is definitely good. Therefore, to replace a new cartridge to print, if the fault is eliminated, is enough to prove that cartridge components have problems, then check the photosensitive drum charging electrode, electrode bias magnetic roller and the photosensitive drum. The electrode is good contact, such as a poor contact, should find and add to repair. (2) then check whether the charging wire and grid are short circuited or out of contact, if they should be replaced, repaired or cleaned. As we know, most of the structures are different from each other due to different models, but t