界面剂介绍（Introduction of interface agents）.docVIP

界面剂介绍（Introduction of interface agents） Introduction of interface agents The interface agent is an adhesive, usually made from vinyl acetate. It has super adhesion, good water resistance and aging resistance. To improve the bond strength of the mortar plastering layer can effectively avoid hollowing, shedding, shrinkage cracking problem. For the surface treatment of concrete, aerated concrete, sand lime bricks and fly ash brick, because these surface absorbent or smooth interface is not easy to cause bonding, resulting in plaster hollowing, cracking, spalling etc.. It can greatly increase the bonding force between old and new concrete and concrete and plastering mortar. Can replace the traditional concrete surface cutting process, improve the surface rendering process of aerated concrete, is an indispensable supporting material for modern construction and decoration construction. Interface agents are usually used on concrete surfaces because the concrete surface is too smooth. Through the use of this product, can make the surface becomes rough, can increase the bond strength, on the base of the shell to avoid hollowing coat, instead of artificial chiseling process. The utility model has the advantages of strong permeability, sufficient penetration of the surface of the layer material, enhancing the adsorbability of the new putty and the base material, and increasing the adhesive capacity. Can also be directly brush and ground material back, depending on the specific material to be determined. Edit this paragraph Dry powder interface agent (emulsion type interface agent (divided into single component and multi component): commonly used VAE (vinyl acetate ethylene copolymer emulsion), emulsion type interface agent, acrylic emulsion type interface agent. Edit the scope of this paragraph The interface agent is suitable for ceramic tile, glass mosaic, tiles, tiles, marble, terrazzo, cement, mortar, concrete, exposed aggregate surface, application of the product in the ol