J-PCB检验规范（J-pcb inspection specification）.docVIP

J-PCB检验规范（J-pcb inspection specification） This article is contributed by cpyi2003 Ppt documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. PCB inspection specification Tony Lin 2008/12/20 One Printed circuit board - PCB The quality of PCB is closely related to the process of SMT. If the problem can be examined by the appearance, it can greatly reduce the manpower, time and cost wasted by the PCBA repair. The inspection specifications vary according to the customer. If there is any dispute under the special specification, the domestic standard is generally based on IPC-A-600E 2008/12/20 Two Substrate plate -LAMINATES Commonly used materials: FR4, 94V-0 above the copper foil adhesion is larger than 8 Pound/Inch base plate and the line has no delamination or separation of a single fracture fabric (white), white spot area can not be greater than half two line spacing fabric (white), white spot length is more than 31mil, and not to be accounted for more than 0.5% of the available area of the plate edge can not have prominent glass (including various notches) plate edge can not have exposed copper substrate in the yellow discoloration phenomenon, or chemical pollution (formerly referred to as green paint) 2008/12/20 Three Text symbol -SCREENED MARKING The text color is white (if otherwise specified according to the project plan) LOGO font symbol clearly recognizable, no fault, fuzzy double printing or appear irrelevant symbols symbols cannot be printed on pad print ink with non conductive and anti solvent and general printing ink to general operating temperature 3M text NO.600 adhesive tape tearing off phenomenon may not print offset may not exceed 10mil 2008/12/20 Four Line -TRACE Two adjacent lines are not allowed while exposed copper or tin, tin or copper exposed not greater than 20MIL and per surface point of the circuit breaker or short circuit line doesnt allow a distorted