开机黑屏、蓝屏、无显示 故障浅析（Boot black screen, blue screen, no display fault analysis）.docVIP

开机黑屏、蓝屏、无显示 故障浅析（Boot black screen, blue screen, no display fault analysis） 2008-08-14 11:49 boot black screen, blue screen, no display fault analysis (1) press the switch button without any reflection, the light is not bright, the fan does not move; Cause: the power is broken and the pipe is burned out; Motherboard and chassis POWER button wiring error. Measures: directly use a screwdriver or ball point pen to connect the two PWRBTN pins on the motherboard, and if you can start, check the chassis buttons and wiring; If there is still no reflection, change the power supply. After the power supply, the motherboard is still not lit, without any reflection, the main board to professional maintenance personnel processing or direct elimination. (two) press the power on button, the power light will go out, the power fan and CPU fan will not move; Cause: power failure; Motherboard fault may have a short-circuit phenomenon. Measure: change the power supply; Clean the motherboard dust, check off the screws on the motherboard, check the power line is cut, short-circuit phenomenon, fan blades cant play on the wire. The above reasons excluded, the fault still, the motherboard, the power from inside the chassis removed, placed on the table, CPU, memory, graphics card, motherboard installed only to boot, if you still can not find, professional maintenance, or directly out of the motherboard. (three) press the boot button, power light, power fan and CPU fan to rotate, BIOS self-test does not start, no alarm sound, screen black screen or show no signal input; Reason: CMOS setting error or BIOS chip fault (such as refresh BIOS failed). Other motherboard failures. Measures: to CMOS discharge (unplug the computer power cord, unplug the motherboard, button batteries, and later installed; Or after the shutdown, the CMOS jumper cap is inserted into the Clear position and is restored to the Normal position in a few seconds; To refresh BIOS, you may need to use the hot swap method or use a