公 路 边 坡 常 见 支 护 方 法（Common support method of highway slope）.docVIP

公 路 边 坡 常 见 支 护 方 法（Common support method of highway slope） The slope rock slope steep intact and used when humianqiang rib type. 1.4.2 construction requirements: (1) entity humianqiang Thickness as high as the wall, the general use of 0.4 ~ 0.6m, the bottom width is generally equal to the top width, plus H/10 to H/20, the level of single barrier height is generally not more than 15m, and the overall height of multi grade parapet wall generally does not exceed 30m. Along the length of the wall, set up a 2cm expansion joint at intervals of 10m, and the joints are filled with asphalt hemp bars. After the discharge hole is made of gravel and sand, the reverse filter is used to remove the drainage behind the wall. The build humianqiang ago all the slope rock weathering layer tofresh cleared of weathered rock rapidly (MICA chlorite schist rock, slope, etc.) the Qing dug fresh rock surface, should immediately build humianqiang. The top should be filled with raw soil to avoid water erosion. (2) the window type humianqiang hole The window hole humianqiang window type is usually arched, 2.5 ~ 3.5m, width 2 ~ 3M, 1 ~ 1.5m radius. The foundation, thickness, expansion joints and the same entity humianqiang hole, as the specific circumstances, using dry rubble, grass or on the surface. (3) humianqiang arch Arch span is small (2 ~ 3M), arch with 10# cement mortar rubble arch, high slope under complete rock height, arch span is large, the concrete arch. 1.5 shotcrete or shotcrete protection [1] 1.5.1 applicable conditions: Suitable for rock slope with bad lithology, lower strength, easy weathering or hard rock layer, weathering and fragmentation, joint development and weathering and spalling of its surface; When rock slope is caused by weathering, spalling and joint cutting, resulting in large area falling and local small collapse and falling rocks, local reinforcement can be adopted to carry out large area shotcrete (shotcrete). The upper rock weathering of high cutting slope in