vvvv数控加工工艺小技巧（Vvvv CNC machining skills）.docVIP

vvvv数控加工工艺小技巧（Vvvv CNC machining skills） General thread for numerically controlled lathe CNC lathe, thread General thread for numerically controlled lathe In the CNC lathe turning metric and inch system, the modulus and size control of the four standard thread, no matter what kind of thread turning, exercise strict relation between the lathe spindle and the tool must be: a turn each spindle (i.e. workpiece turn), the tool should be uniformly moving a (piece) lead the distance. Through the analysis of the ordinary thread, strengthen the understanding of ordinary thread, in order to better processing common thread. Dimensional analysis of plain thread The numerical control lathe to the ordinary thread processing needs a series of sizes, the ordinary thread processing needs the size computation analysis, the important following two aspects: 1 、 diameter of workpiece before thread processing Considering the expansion of thread processing, the diameter of the workpiece is D/d - 0.1P before the thread processing, that is, the thread diameter is reduced by 0.1, and the pitch ratio is 0.1 to 0.5 smaller than that of the big thread. 2, thread processing feed The amount of thread added to the tool can be referenced to the bottom diameter of the thread, that is, the final position of the cutter. The thread path is: big diameter - 2 times higher; the tooth height is =0.54P (P is pitch) The feed amount of thread processing shall be reduced continuously, and the specific feed amount shall be selected according to the cutter and work material. Tool setting and tool setting of common thread cutters The installation tool is too high or too low to be too high, cutting depth, after the knife face against the workpiece, the friction force is increased, even the workpiece bending, resulting in eating knife phenomenon; the chip is too low, not easy eduction, turning the direction of radial force is the center, with transverse screw and nut gap is too large, resulting in depth continuousl