无线nrf24l01台产接收c程序.docxVIP

/******************************************************************************************************************************************************************/#include main.h#include nrf24l01.hsbit CSN = P1^3;sbit MOSI = P1^5;sbit MISO = P1^6;sbit SCK = P1^7;sbit CE = P1^2;sbit IRQ = P1^4;uchar TX_ADDRESS[TX_ADDR_WIDTH] = {0x34,0x43,0x10,0x10,0x01}; //本地地址uchar RX_ADDRESS[RX_ADDR_WIDTH] = {0x34,0x43,0x10,0x10,0x01}; //接收地址ucharRX_Buffer[4];/*bdata用于将变量定义在可位寻址片内数据存储区,允许位与字节混合访问*/ucharbdata state; // 状态变量sbit RX_DR = state^6;// 接收成功中断标志sbit TX_DS = state^5;// 发射成功中断标志sbit MAX_RT = state^4;// 重发溢出中断标志/** * SPI读写函数(SPI时序模拟) * @input byte: */uchar SPI_RW(uchar byte) { ucharbit_ctr; for (bit_ctr=0; bit_ctr8; bit_ctr++) { MOSI = (byte 0x80); // output byte, MSB to MOSI byte = (byte 1); // shift next bit into MSB.. SCK = 1; // Set SCK high.. byte |= MISO; // capture current MISO bit SCK = 0; // ..then set SCK low again } return byte; // return read byte }/** * 设置寄存器的值 */ucharSPI_WriteReg(ucharreg, uchar value) { uchar status; CSN = 0; // CSN low, init SPI transaction status = SPI_RW(reg); // select register SPI_RW(value); // ..and write value to it.. CSN = 1; // CSN high again return(status); // return nRF24L01 status byte } /** * 读取寄存器的值 */ucharSPI_ReadReg(ucharreg) { ucharreg_val; CSN = 0; // CSN low, initialize SPI communication...SPI_RW(reg); // Select register to read from.. reg_val = SPI_RW(0); // ..then read registervalueCSN = 1; // CSN high, terminate SPI communication return(reg_val); // return register value } /** * 读出接收缓冲区数据 * @input reg:寄存器地址, *pBuf:存储读出的数据 */ucharSPI_ReadBuf(ucharreg, uchar *pBuf, uchar bytes) { uchar status, byte_ctr; CSN = 0;