celect (cummins electronic control) celect …（celect(康明斯电子控制) celectu2026）.pdfVIP

Celect (Cummins Electronic Control) Celect Plus Injector Adjustment Name: ________________________________ Date: ________________________________ Cummins CELECT and CELECT Plus system injectors are used on Cummins electronically controlled engines between 1990 and 2001 in L, M N series engines. Injector adjustment is accomplished by applying the correct preload to the timing plunger of the injector when the engine is at 45-degrees before TDC. 1. Injector hold-down bolts should have been previously torqued down to 45-Ft/lbs – verify proper hold-down torque. Rotate engine to valve set marks on accessory drive pulley for cylinder you will adjust v alves and injectors. 2. Identify the cylinder and correct rocker arms for adjustment. • There are three housings on an N-14. • The intake levers are located near the center of the rocker housings and the exhaust levers closest to the outside of each housing. • Adjust both valves per specification on engine data plate. 3. The injectors are adjusted at the same time as the valves. Use the accompanying chart to determine which cylinder to adjust. Both valves must be closed on the cylinder you are adjusting the valves. The rocker levers will move from side to side. List the companion cylinder for each of the following cylinders: 1- ___ 2 -___ 3-__- 4-___ 5-___ 6-___ What valve or injectors can be adjusted in each of the following accessory drive positions? A _______ B______ C______ 4. Injectors are adjusted using the following method: • Bottom the injector plunger out three or four times to remove fuel beneath the timing plunger by tightening and loosening the injector adjustment screw. Do not