电梯（Elevator.）.doc

电梯（Elevator.） Kone elevator data - KONE error code, News code, KONE elevator data - KONE error code, News code, fault name, cause, status, operation 0001 the driving time is long, the position signal 30/B30 has not changed after a period of running time, and the switch is stopped immediately 0004 three consecutive failures of synchronous operation, three consecutive simultaneous operation, the system can not correctly receive the deceleration level signal, after three failures, stop at the end of the station power off 0007 door switch 308030 clamping, start a period of time, did not detect the falling edge of the 30/B30 signal, the door area switch 30/B30 has been effectively running to the target floor, the door does not take the car, power off or maintenance 0008, NVRAM damage or capacity is not enough, when the power supply is detected, the capacity of the NVRAM is not enough. Replace the NVRAM The 0014 gate check circuit does not release the 486.443; the 1.443:2 either runs 2 consecutive times (ACO/ACL) to the destination floor, leaving the service switched off The 0015 gate check circuit has no pull in 486.443; the 1.443:2 either runs 2 times continuously (ACO/ACL) to the destination floor, leaving the service off 0021 the safety loop is not safe, the input circuit is 1, no voltage is stopped immediately. The safety circuit is connected 0022 hall door lock, safety loop, enter 3, no voltage, stop the door lock immediately 0023, the car door lock is not safe, enter 2 no voltage, stop the car door lock immediately 0025 start system failure, elevator stop, the main contactor is not released, do not start the main contactor troubleshooting 0026 drive system, fault drive system detect fault (v3FCK light is not bright), do not start power off or repair 0039 short 77 buttons stuck on the LCEBOPU plate and 77 short circuit card button does not start until the release button. 0042 car lighting monitoring car lighting, no electricity to the destination floor, from service