优化开机启动（Optimize boot）.docVIP

优化开机启动（Optimize boot） The computer is too slow to start too many common heart disease in each computer, let the computer boot faster is the common aspiration of everyone, I summed up in the process of using computer to speed up boot the computers fifteen, to share with you. First, the BIOS optimization settings On the home page of the BIOS setting, we go to the advanced BIOS features option and move the cursor to the frist boot device option, Press pageup and pagedown to select the default value of floppy, which means that when you start, the system reads the boot information from the floppy drive first, The machine will lengthen the starting time of doing so, minimize the floppy drive life. So we have to choose hdd-0 to start directly from the hard disk, so it will start several seconds faster. In addition, for the above 1mbmemorytest in the BIOS setting, choose disabled, and for quickpoweronselftest, choose enabled. In the advanced chipset features set, the acceleration of the impact of the machine is very big, please pay more attention to. Change the bank 0/1 DRAM timing from 8ns/10ns to fast or turbo. Turbo is faster than fast, but not very stable. Fast is recommended. If the memory is good, you can choose turbo and try to change it back to fast. For memory quality good memory, it is recommended that the SDRAM CAS latency option is set to 2, so that it can speed up oh. Newer motherboards support agp4x, if agp4x also supports your graphics card, then in the agp-4xmode the Department will activate, is selected as the enabled, it will be better to play cards, to speed up the startup speed of the system. Two, start DMA mode, increase the speed of hard disk Using udma/33, 66, 100 technology of the hard disk, the highest transmission rate is 33mb/s, 66mb/s, 100mb/s, in theory, is the IDE hard disk (here refers to the PIO Mode4 mode, the transmission rate is 16.6mb/s) The transmission rate is 3~6 times, but in the windows, the DMA is disabled in the default setting, so