注塑成型缺陷及解决方法（Defects and solutions of injection molding）.docVIP

注塑成型缺陷及解决方法（Defects and solutions of injection molding） Injection molding defects and solutions.Txt this is a taboo one after another collapse of the times, no one can stop you, only you block yourself, your taboos more, less achievements. Inferiority has a variety of grades, the highest level of inferiority, to boast of what they do, is a genius. Defects and solutions of injection molding Section 1 missing material One meaning: melt material into the mold cavity is not filled completely, leading to plastic parts missing. Two, causes and elimination methods: Equipment selection is improper: in the selection of equipment, the machines adhesive volume must be greater than the amount of adhesive products, injection molding parts weight can only account for 85% of the total adhesive flux. Insufficient feeding: whether there is a bridging phenomenon at the feeding port, the injection stroke of the screw rod can be appropriately increased, and the feed quantity is increased. The raw materials of poor liquidity: stagnation improving the defects of die casting system, a reasonable set of glue pouring position, expand gate runner and sprue size and larger nozzle with appropriate temperature to improve raw material. The gating system design unreasonable: the design of gating system, should pay attention to the gate balance, each cavity of the plastic parts of the weight should be proportional to the size of the gate, is each cavity simultaneously filled with the gate location to choose in the original wall, can also be used to design the runner balance arrangement. The mold venting: check whether the cold cavity, or whether the location is correct, the mold cavity is deep, should add the exhaust groove and the vent hole in less injection parts in the mold surface can be arranged on the depth of 0.02 -0.04mm, width of 5-11mm vent, the vent should be set at the end of filling at the cavity. In addition, the process can be improved by increasing the mold temperature, reducing th