洁净工程观感质量要求（Quality requirements for clean Engineering）.docVIP

洁净工程观感质量要求（Quality requirements for clean Engineering） Quality requirements for clean Engineering Quality of inspection, qualified inspection points, excellent quality requirements Fitting part Indoor ceiling Hood ceiling Guarantee item: The cover panel must be firmly installed without delamination, warping, folding, missing angle and falling angle. The main beam, joist (main reinforcement, transverse brace) must be installed in correct position, and the connection is firm and free of looseness. Basic project The cover panel surface Quality: smooth and clean surface Excellent: surface smooth, clean, consistent color, no pollution, anti rust, pitting and hammering The joint or layering Quality: the seam width is uniform, the belt is straight and free of warping Excellent: the seam width is uniform and neat; the width of the strip is uniform and straight; the seam is tight The wood and steel skeleton hangers, beams, joists (vertical ribs, transverse brace) appearance Qualified: slightly bent, but does not affect the installation; wooden boom without split Excellent: straight, no bending and no deformation; wood suspender without split The filling material Qualified: dry material, laying thickness meet the requirements Excellent: on the basis of conformity, the thickness is uniform The lath and plaster layer of metal net Qualified: gray lath nails knot firmly, the joint in the grid (vertical bar), the gap size meets the requirements; metal mesh nails, the joint on the grid (vertical bar) Good: on the basis of conformity, staggered gray lath layout, the size of the right seam meets the requirements; metal mesh nails flat, without raising edges Allowable deviation item: Qualified: the surface is smooth, the vertical surface, the layering, the seam is straight, the seam height difference, the layering spacing is consistent, and so on most parts of the project meet the allowable deviation value Good: most parts of the above items meet the allowable deviation value Two, int