活动地板（Movable floor）.docVIP

活动地板（Movable floor） Operation instruction ---- movable floor I. material requirements 1. the varieties and specifications of the movable floor are determined by the designer and shown in the construction drawing. Procurement must be in accordance with design requirements to buy matching series of qualified products. 2. the floor bearing capacity of the movable floor shall not be less than 7.5Mpa, and the system resistance shall be 105-1010 ohms. Plate surface should be smooth, solid, and has the characteristics of wear resistance, moisture resistance, flame retardancy, pollution resistance, aging resistance and static electricity, etc., and the technical performance shall be in line with the current national standards. 3. epoxy resin, talcum powder, foam, wood, rubber, aluminum and iron, aluminum and other materials to meet the requirements of angle. Two 、 main machines and tools The 1. level, the level of scale, iron iron feet, 2-3m by foot plate, ink or line bag, small line, line sinkers, broom, box ruler, steel ruler, nails, wire, red pencil, oil brush, surgery, sucker, trolley, dustpan, small iron hammer, alloy steel flat drills, cutting board for a circular saw, cutting aluminum toothless saw, woodworking saws, axes, and plane scales, wire pliers, wooden, cotton yarn, small shovel, iron screw wrench, tool bags, foam slippers etc.. Three, operating conditions 1. according to the requirements of design drawings, prior to the laying of the floor to do grassroots activities (mostly the cement floor or terrazzo floor etc.), primary surface should be smooth, clean, no dust, moisture content is less than 8%. Should be cleaned before installation and painted with insulating grease or paint on the surface if necessary. If the room is rectangular, the adjacent walls must be perpendicular to each other. 2. installation of movable floor surface, must be completed within the room and more than the floor surface bearing equipment into the room after a predetermined position,