液晶维修经验（LCD maintenance experience）.docVIP

液晶维修经验（LCD maintenance experience） Hisense TLM40V68PK---- has no sound and no grating. Detection of individual voltage points is normal (including bus), only the ON/OFF voltage (3.5V) is not replaced, and the N24 (flash program memory) is removed. This kind of fault is particularly large. In the logic board without power supply, more than 32 inches of the screen is generally black screen, 26 inches below the screen is generally white screen. LVDS signal output pin voltage is generally 1.2V, the signal is 0.2Vpp. LVDS interface abbreviation: Single six: Pinyin abbreviation D6L English abbreviation SI6L Single eight: Pinyin abbreviation D8L English abbreviation SI8L Double six: Pinyin abbreviation S6L English abbreviation DO6L Double eight: Pinyin abbreviation S8L English abbreviation DO8L 15 inches below the LVDS screen, mostly 3.3V power supply, 17 inches, 19 inches more power supply for the 5V Driver selection: 1, the driver board is different (chip program is different), the driver can not be common 2, in the same kind of drive board driver, if a and screen interface type is the same, B and bit number the same, C and screen supply voltage the same, generally compatible Brightness control terminal - if the tube is not lit or dithered, the brightness control terminal can be connected across 1 thousand ohm resistors to the +5V or ground. The BLON terminal can be shorted to the +5v or connected with the +12v via several thousand ohm resistors TL494 -----1 (IN+) 2 feet feet (IN-) and 16 feet (IN+) 15 feet (IN-) with the same error amplifier, the two output of the error amplifier are connected together, the output high level, so the driver output, when the voltage interruption, IN+ voltage greater than IN- when to remove the protection, protection, can be 1 feet and 16 feet to the ground. But in doing so, the steady flow function is lost. The design of TL494 protection function is different for each application circuit. The secondary shunt capacitor of high voltage tran