精轧除鳞（Finish descaling）.docVIP

精轧除鳞（Finish descaling） 3, descaling introduced The finishing descaling box is located in front of the F0 finishing mill, which is used to eliminate the two oxide scales on the surface of the workpiece. Type: high pressure water descaling device with front and rear pinch rolls Header size: four rows up and down, two rows Number of nozzles: on the input (25 nozzles) and 25 under the nozzle Output (nozzle number is 25), lower (nozzle number is 25) Nozzle type: high pressure nozzle: hydraulic pressure: (14-18) MPa Distance between nozzles from slab (25-50mm of Haixin) (Mei Gangs 250-300mm) Adjustment mode of upper pinch roller: (adjustment of cylinder with air cylinder) (adjustment of Mei Gang hydraulic cylinder) 1 proximity switch 2 induction plate 3 lifting mechanism The fine descaling box is composed of a front, a middle, a back box, a left and a right side plates, an upper and a lower collecting pipes, an upper collecting pipe height adjusting device, a high-pressure nozzle and a side spraying device. The slab coming from the furnace area is sent into the coarse descaling box by the rough descaling roller table to the high-pressure nozzle. The two groups of upper and lower high pressure nozzles in the descaling device are sprayed in the direction of the counter strip to realize the removal of the iron oxide sheet for the billet. To ensure the high pressure nozzle blow force, on the descaling header pipe is provided with a nozzle height adjustment device, the hydraulic cylinder through a nozzle height change four linkage, to ensure that on the surface of the plate distance is 200mm. Water sprayed high water collecting tank to collect through the scraper and the operation side of the tube into the recovery device; in the descaling box outlet side is provided with a side spraying device, used to sweep the slab which has not removing iron oxide scale net. When the pipe is being repaired or replaced, the upper cover with a water collecting tank is hoisted away by the ove