钻井新技术（Drilling new technology）.docVIP

钻井新技术（Drilling new technology） The casing cementing technique in a super deep well Abstract: with the deepening of exploration and development, the number of deep Wells and ultra-deep Wells is increasing, and the bottom of the casing is becoming larger and larger, and the lower casing technology has also proposed higher and higher requirements. Before each of the casing, carefully Wells well well-prepared, adjusted well drilling fluid performance. The strict implementation of the technical measures in the casing operation ensures that the casing is well down to the intended well. Key words: super-deep well casing design, casing drilling, cementing process, typical example 1. Super-deep well casing design (a) the ultra-deep well should mainly solve six aspects of technical difficulties (1) the limitation of the deep well structure can not meet the requirements of cementing quality. (2) severe wear of technical casing leads to difficulty in drilling. (3) the design of casing string is difficult to improve, and the reliability of cementing tools is poor. (4) the underground water quality has changed greatly, resulting in serious corrosion of cement rock. (5) the hole wall stability problems such as hole leakage and well surge are prominent. (6) traversing the high pressure layer and low-pressure salt-layer and sulfur-bearing stratum. (2) casing design Although there are mature design methods and design standards, it is difficult to determine the design of deep well casing column because of the external calculation conditions. This is often the case: according to the design of a good string, in the future production process of collapse, fracture, deformation, wear and so on. For example, the formation pressure of a well is as high as 124MPa. After completion, the casing of V150, P110 and nkt140trapezoid is used to test the casing. Therefore, the casing design of the super-deep well should increase the safety factor appropriately and measure the various production condit