钻孔灌注桩工程事故预防措施（Accident prevention measures for bored pile engineering）.docVIP

钻孔灌注桩工程事故预防措施（Accident prevention measures for bored pile engineering） Accident prevention measures for bored pile engineering Bored piles with low noise, small vibration, non compaction and minor impact on the surrounding environment and the adjacent buildings, can through all kinds of complex formation, and form a larger single pile bearing capacity, adapt to various geological conditions and different scale advantages, such as buildings, in Bridges, buildings, such as hydraulic structure is widely used in engineering, and has become an important means of pile type. With the need of social and economic development, the pile length and pile diameter of bored piles are increasing, the bearing capacity of single pile is higher and higher, and the design of single column is possible. For long pile, big pile, its construction difficulty is big, easy occurrence quality accident. However, the single column design has high quality requirements for the pile. After the quality accident, it is difficult to consolidate and the cost is high. Therefore, it is necessary to analyze the common quality accidents of bored piles, find out the causes of quality accidents, study corresponding countermeasures, and try to prevent quality accidents. Problems of geological exploration data and design documents Geological exploration mainly exists such problems as too large spacing of exploration holes, too shallow hole depth, insufficient quantity of geotechnical tests, irregular geotechnical sampling and geotechnical tests, resistance to pile friction and pile end resistance. The design documents mainly exist problems such as the lack of careful digestion of geological exploration data, the improper selection of pile type, and the high level of the construction site. Therefore, the geological exploration materials and design documents should be carefully reviewed before the construction of pile foundation begins. In addition, large space to pile foundation bearing layer thickness change,