航海类专业知识（Nautical expertise）.docVIP

航海类专业知识（Nautical expertise） Anchor program Connect the power supply test anchor to determine whether it is working normally. 2. Lock the brakes of the anchor chain, remove the storm cover of the anchor chain and the waterproof cover of the chain pipe, and open the anchor chain stopper to make the anchor labored on the brake belt. Combine the clutch, loosen the brake band, loosen the anchor and anchor the anchor and hang it outside the boat. 4 then brake the brake, remove the clutch, and the anchor is now in an immediate condition. Report captain anchor is ready. 5 has the anchor, as the chief officer should be recognized in the outboard anchor under no boat or barge, loosen the brake immediately instructed the anchor machine operators, to anchor for gravity falling rapidly, after being anchor exactly, immediately show anchor light and/or anchor ball and close the navigation lights. 6 according to the requirements of the loose chain, each chain shall ring the number of the report of the bell by the deck, and the chief officer shall, at any time, release the cable of the chain from the number and direction of the cable to the drivers table. Anchor has been hold seven judgment, and walk out enough chain length as planned, should play the stopper, and pressed the stopper bolt, cable demanding in the stopper and brake wear, release the clutch to cut the anchor mechanical and electrical source, anchor job to come to an end. Anchor program 1 test anchor, confirm the normal operation, close the clutch, loosen the chain and brake. After receiving the anchor password, the officer will instruct the anchor operator to anchor the anchor according to the anchor chain condition, and report the chains number and direction to the captain at any time. If the anchor chain is too heavy, the anchor will not be moved, so it should be paused for a moment, and then the rudder will stay with the chain after the anchor chain. The maximum load of the instantaneous anchor at the bottom of the