S6062-05阀门驱动器.DOC

S6062-05Nm Series Electric Control Valve Actuators (Self-Testing) Two models: S6062-05A: Analogue Model 0~20mA DC control signal providing proportional control S6062-05D: Digital Model, providing incremental control Specifications: Model S6062-05D S6062-05A Action Reversible Direct or reverse Control Incremental Proportional Input signal ――― 0~10V,2~10V;0~20mA,4~20mA Output signal 0~10V,2~10V;0~20mA,4~20mA Motor Synchronic and reversible Rating 24VAC 50/60Hz 2.7W Consumption ――― 2W Force 500 N Material Gear: stainless steel, nylon Bracket: galvanized steel plate Stand: die cast aluminum Cover: ABS engineering plastics Protection IP40 Full stroke time 10mm stroke is 100s（ frequency 50HZ） 10mm stroke is 85s（ frequency 60HZ） Actuator Max. Stroke 20mm Ambient temp. Operation: -15 ~ 55oC Storage: -20 ~ 65oC Relative humidity Non- condensing 90% non-condensing Net weight 0.66Kg 0.72Kg Mounting The mounting position is upright to horizontal. It is recommended that the valve be mounted in the upright position in an accessible location. Sufficient clearance must be allowed for actuator maintenance or detaching. Mounting Operation Instruction Attention: The actuator should be protected from dripping water that could enter the housing and damage the mechanism or motor. The actuator must not be covered with insulating material. Disconnect the power supply before repair or maintenance to avoid personal injury or machine damage. 4. Do not touch or disconnect the wire when the power is on. Wiring Diagram S6062-05D S6062-05A Wiring Diagram (S6062-05A Valve Actuator) S1, S2 Dial Switch Function Instruction： S1 Dial switch setting： Position 1 ： “OFF” is for voltage output signal，”ON” is for current output signal. Position 2 ： ”OFF” is for voltage input signal，”ON” is for current input signal. S2 Dial switch setting： Position