03g101的权威解释施工、监理、造价必读(梁篇)（03g101s authoritative explanation, construction, supervision and cost must be read (Liang Pian)）.docVIP

03g101的权威解释施工、监理、造价必读(梁篇)（03g101s authoritative explanation, construction, supervision and cost must be read (Liang Pian)） 03G101s authoritative explanation, construction, supervision and cost must be read (Liang Pian) beam The beam problem (1): 03G101-1: two calculation methods of end column bearing length into the flat beam longitudinal reinforcement on 55 as an example, the beam longitudinal reinforcement into the anchoring portion of the end column has 15d, if you put it in with the column longitudinal reinforcement with a vertical level, will cause bar too close, it is not right. As you can see from the picture, you should arrange it from the outside to the inside into several vertical layers. However, in the calculation process, there are two different algorithms, and these two algorithms fit the requirements of the atlas; The first algorithm is calculated from the lateral to the medial end column, first consider the protection layer column longitudinal reinforcement, according to certain spacing (calculated) the first row of the upper longitudinal bar, second row of upper beam longitudinal reinforcement, then calculate the lower longitudinal reinforcement, beam end, ensure straight anchorage length of the inner bottom longitudinal reinforcement not less than 0.4laE; Second algorithms, is calculated from the medial end to the lateral column, to ensure straight anchorage length of longitudinal reinforcement on the innermost layer of the lower beam of not less than 0.4laE, followed by the outward projections, in so doing, the outermost layer of the upper beam longitudinal reinforcement straight column longitudinal reinforcement and anchor portion may be separated by a distance. These two algorithms, the first one is more safe, the second kind of some steel bars. I wonder if the atlas designer agreed on which algorithm to use In a beam problem (1): according to the first algorithm. If column section height is big, press 54 page Note 6 implement. The beam problem