bcran课本命令回顾（Bcran textbook command review）.docVIP

bcran课本命令回顾（Bcran textbook command review） BCRAN textbook command review BCRAN (building Cisco remote access network) The third part is to enable on-demand connections to the network center The fourth chapter configure modem asynchronous connection 4.5 asynchronous connection configuration Common modem standards Slot number line number range 0 1~32 1 33~64 2 65~96 3 97~128 Formula: interface number = (32* slot number) + unit number + 1 The service provided and the port number corresponding to the line and loop group The number of TCP ports provided by a separate line for the services provided, the base port number for the base cycle group, and the base number for the TCP Telnet protocolOriginal (Raw) TCP protocol (excluding Telent)Telnet protocol, binary modeX remote protocol 900010000 When reverse Telnet is on a line, the protocol is configured as: Router (config-line) transport output protocol {lat mop # | | | Nasi none pad rlogin telnet | | | | v120} Router (config-line) transport output all # What must be configured is: Router (config-line) transport input all # Router modem inout (config-line) # 4.5.1 executable connection command Executable command line description Telnet host | IP address [port] [/debug] to establish a host (or to a specific port connection). Optionally, debug can provide information associated with the connection through the display record (log) message Show session displays the session for the current connection Disconnect [session-number] terminates the specified connection; if the connection is not specified, the most recent connection (that is, the current connection) is terminated Ctrl + Shift + 6 + X interrupts the current session, first pressing both Ctrl, Shift, and 6 keys, and then pressing the X key 4.5.2 lines (Line) and numbers Line type, line number CON - Console, line, Line = 0 TTY - Asynchronous, line, Line = n (Note: n indicates the number starting from 1) AUX - Auxiliary, line, Line = last_tty