矢量变频（Vector frequency conversion）.docVIP

矢量变频（Vector frequency conversion） Power load in power grid, such as motor, transformer and so on, mostly belongs to inductive load, and corresponding reactive power should be supplied to them during operation. After installation in the power grid parallel capacitor and reactive compensation device of reactive power can provide the perceptual load consumption, reduce the reactive power grid, power supply by the transmission line to the inductive load, due to the reduction of the reactive power flow in the power network, thus reducing the transmission lines and transformer for reactive power due to the power loss, this is the reactive power compensation. brief introduction In large systems, reactive power compensation is also used to adjust the voltage of the grid and improve the stability of the grid. In the small system, the three-phase unbalanced current can be adjusted by the proper reactive compensation method. According to the Wangs theorem, an inductance or capacitor that is connected between phase and phase can transfer active current between phases. Therefore, the system for three-phase current unbalance, as long as the proper capacitors connected to different capacity between each phase and each phase and zero line, not only can the phase power factor compensation to 1, but also can make the active current of each phase equilibrium. Edit the basic principles of this paragraph The basic principle of reactive power compensation: the power output consists of two parts; one is the active power; two is the reactive power. The direct consumption of electricity, the electrical energy into mechanical energy, heat energy, chemical energy or energy, the energy of power, this part is called active power; power consumption just put; electric energy is converted to another form of energy, such as necessary conditions, electrical equipment and can work, this is in the power grid and power conversion cycle, the power called reactive power, such as electromagnetic component