Analysis of wear of cemented carbide cutting （硬质合金切削磨损分析）.pdfVIP

Wear 271 (2011) 2426–2432 Contents lists available at ScienceDirect Wear j o ur nal ho me p age: /locate/wear Analysis of wear of cemented carbide cutting tools during milling operation of gray iron and compacted graphite iron M.B. Da Silva a,∗ , V.T.G. Naves a , J.D.B. De Melo a , C.L.F. De Andrade b , W.L. Guesser b,c a Federal University of Uberlandia, Av. Joao Naves de Avila 2121, Uberlandia, MG, 38400-089, Brazil b Tupy S.A., R. Albano Schmidt 3400, Joinville, SC, 89227-901, Brazil c UDESC, R. Paulo Malchitzke, s/n, Joinville, SC, 89223-100, Brazil a r t i c l e i n f o a b s t r a c t Article history: Cast iron is used to manufacture engine blocks and heads due to its mechanical and physical properties. Received 31 August 2010 The thermal conductivity and vibration absorption are some fundamental properties for these applica- Received in revised form tions. Compacted graphite iron (CGI) has higher mechanical strength than gray cast iron and can be a 26 November 2010 great advantage in these types of mechanical parts. Although mechanical and physical properties are Accepted 27 November 2010 similar for both materials, CGI is considered to have poor machinability compared to gray cast iron, even when compared to alloyed gray cast iron. So it is important to investigate the behavior of the CGI for the most important cutting processes.