手动装GHOST11（Hand installed GHOST11）.doc

手动装GHOST11（Hand installed GHOST11） How to manually install the system using GHOST How to manually install the system using GHOST (caution against danger of corrupt data) First, in the program to find the GHOST program to start, where the use of GHOST V11, the other version of the operation is basically the same. Two, in the operation before I hope you can understand the work flow of GHOST, the part of the beginning of the article mentioned here, I use an analogy to explain, and we often use GHOST as WinRAR software, it is on the operation of the object is the entire partition, work process is this: we should first find the original file, the file format is GHO, which when in rar, and then select the installation drive installed, this step is equivalent to rar of the decompression process. Three, the specific operation, such as: LOAD/DISK/FROM IMAGE Select the From Image window as follows: The GHO file in the compact disk Find the GHO file (directly use the CD-ROM to do U disk boot disk usually in system, if you use the morning breeze, so please GHO copied to the U disk) is selected, as shown below: 1, PRIMARY Point OK, as follows: 1.LOCAL This step is to show the disk operation, be careful not to choose wrong, otherwise the consequences will be grievous. In order to avoid novice errors, my advice is to remove your mobile hard disk while installing the system. If you have two hard drives on your machine, please identify them carefully. Choose the first one here: This is to choose the partition, but also be careful (error recovery, resulting in data corruption is difficult to recover), carefully identify, look at the size, usually written Primary is. Next is the point of yes, and the progress bar is over, choose to restart the computer on it. The next step is the same as the automatic installation restart, not to mention. Manual Ghost using tutorial 2008-12-19 22:56 One, what is Ghost? Ghost (ghost) software is a Symantec Corp in the United States launched a good hard