夏普复印机错误代码（SHARP copier error code）.docVIP

夏普复印机错误代码（SHARP copier error code） SHARP digital copier maintenance code, fault code daquan!!! 1-1 confirm the mirror device action 1-2 confirm sensor action of optical system 1-6 mirror scanning continuous action 2-1 SPF continuous action 2-2 confirm the SPF sensor action 2-3 make sure the SPF motor is moving in the direction of moving 2-4 make sure the SPF motor reverses direction 2-8 confirm the SPF feed solenoid action 2-9 RSPF turn electromagnet movement check Check the electromagnet movement of the 2-10 RSPF door 2-11 make sure the SPF PS releases the solenoid valve action 3-2 make sure the move sensor action is removed 3-3 make sure the pager moves moving 3-4 confirm the movement of the separation plate (check if it is turning properly) The 3-11 page for in-situ action confirmation 5-1 make sure the buckle panel shows (panel LED lights are all bright seconds) 5-2 make sure that the heating lamp is on (50 seconds on the fuser light and 5 times) 5-3 make sure the copier light is on (10 seconds concentration key to change brightness) 6-1 confirm the action of the feed solenoid valve (50 seconds interval drive 20 times) 6-10 drive main box half round roller 7-1 preheating time means JAM aging 7-4 preheat omitted 7-6 intermittent aging with paper 7-8 preheat time indication 8-1 copy mode development bias output 8-2 copy mode the main charger gate voltage (High state high) output 8-3 copy mode the main charger gate voltage (Low state low) output 8-6 transfer voltage output 8-10 print mode development bias and control loop action confirm and adjust 8-11 print mode master charger gate voltage (High status) and control loop action confirmation 8-12 print mode master charger gate voltage (Low status) and control loop action confirmation 8-13 FAX mode development bias and control loop actions are confirmed and adjusted 8-14 FAX mode master charger gate voltage (High status) and control loop action confirm 8-15 FAX mode master charger gate voltage (Low status) and contro