尾轴管（Stern tube）.docVIP

尾轴管（Stern tube） 1, overview Stern tube finishing, no allowance, welding installation process, suitable for lubrication, water lubrication, a variety of conventional Wheels, cargo ships, etc. - the ship shaft diameter of 150 mm in ~500 mm, 8000 mm in length. The process includes roughing, assembling, finishing, drawing, welding and welding of stern tube. 2 、 the rough machining of stern tube parts 2.1 inspect the front and rear axle hub and seamless tube according to the rear axle parts rough car size diagram (YTHW611-424-02-08) Margin. 2.2 boring machine shaft tube end two, first check the shaft tube bending, should not exceed 2 mm, two end processing, inverted welding Mouth, according to the size of the drawings processing length, processing before and after the bore of the shaft tube, should be positioned with the front and rear hub location, with boring The accuracy is based on the base hole system, and the 4 stage precision machining is done excessively. After the shaft tube is processed, the upper platform is drawn out of the outer circle of the axle tube The location of the front and rear hub and the location of the filling hole, drilling, reaming. Two row four equal position line. 3, tail tube assembly process 3.1 assemble tail tube and front axle hub. Place the front axle hub vertically on the welders platform, and then lift the shaft vertically. The alignment has been drawn The docking line is. Spot weld a few points and check by pull line. The front axle hub axle tube and outer circle of the parallel degree of less than 1 mm, then Turn 45 degrees. Ensure that the parallel, interrupted by electric welding. 3.2 also assemble the rear axle hub and measure parallelism. Ensure three on the same axis, the coaxiality is less than or equal to 1 mm. 3.3 welding technical requirements 3.3.1 preparation before welding For ease of welding, check the concentricity of the two axle hub, convenient and accurate, it is necessary to make a horizontal tire frame, but it shou