数据车床加工精度（Machining accuracy of data lathe）.docVIP

数据车床加工精度（Machining accuracy of data lathe） 1 programming coordinates When the parts are machined and the tool path is determined After that, the programming coordinates of the cutter point are correctly calculated. If the coordinates of the cutter points are calculated wrong or the error is greater, Then it will lead to larger size error, or even not Qualified. 1.1 reasonable programming size The spare parts have matching dimensions and free sizes We all have tolerances, and we must take them into account when programming Take into account. For example, the diameter of a shaft is 36mm, programming can not use nominal size 36 as The coordinate values of the cutter points must be calculated in terms of dimensional tolerances Otherwise, the machined parts may not meet tolerances O. Its programming size should be calculated at half the tolerance zone, That is a o.ol6ram / 2= 0.008ram, so, for Cheng Chicun: 35.992ram. Also, for example, 5 0h 7, check match tolerances, tolerances Is 50ram, the value of a 0.025mm / tolerance: 2= 1, 0, l, 25mm, programming size: 49. 988mm. 1.2 calculation of inside diameter programming dimension when machining thread When machining threads, there is a squeeze out of the tool The outer diameter of the outer thread becomes larger while the inner screw is pressed The phenomenon that the inner diameter of the thread becomes smaller affects the fit of the thread In order to consider this size change in programming. Calculation of 1.2.1 major diameter of external thread In general, the programming dimensions of the outer thread diameter are: The nominal diameter of the outer thread is subtracted from the 0.1 pitch. Such as: Processing M30, X, 2ram external thread, turning outside the circle The diameter should be 30 - 0.1 X 2:29.8ram as Programming size. Calculation of 1.2.2 thread diameter In general, the bore diameter of the inner thread is greater than that of the inner thread The nominal diameter of a pitch value. For example, turning M 40 A