新时达SM-01-F输入输出接口说明（Step SM-01-F input and output interface specification）.docVIP

新时达SM-01-F输入输出接口说明（Step SM-01-F input and output interface specification） Step SM-01-F input and output interface specification Step SM-01-F input and output interface specification Xinshida elevator input and output interface definition: The JP1, JP2, and JP3 are external switch signal inputs, JP1.1: input X0, repair signal, disconnect for repair, shut for automatic (type of input can not be changed) JP1.2: input X1, uplink signal. During the overhaul, it is closed to move up, and the driver is closed to uplink (input type can not be changed) JP1.3: input X2, downlink signal. During the overhaul, it closes as a point and moves down. When the driver is closed, it is closed down (the type of input can not be changed) JP1.4: X3 input terminal for uplink multi switch, 2 m / s or more lift requirements, (the input type can change the value of the factory is closed, low speed lift without this signal, please set the input type X3 is normally open) JP1.5: X4 input terminal for downlink multi switch, 2 m / s or more lift requirements, (the input type can change the value of the factory is closed, low speed lift without this signal, please set the input type X4 is normally open) JP1.6: input X5, uplink limit switch (input type can be changed, factory value is normally closed contact) JP1.7: input X6, down limit switch (input type can be changed, factory value is normally closed contact) The JP1.8: input X7, uplink speed switch. (single terminal input type can change the value of the factory is normally closed contact) JP1.9: X8 input terminal for single downlink switch. (input type can change the value of the factory is normally closed contact) JP1.10: input X9, upper flat dry reed (input type can be changed, factory value is normally open contact) JP2.1: input X10, lower flat dry spring (input type can be changed, factory value is normally open contact) JP2.2: input X11, governor fault output signal (input type can be changed, factory value is normally open contact) JP2.3: