显卡维修总结（Video card maintenance summary）.docVIP

显卡维修总结（Video card maintenance summary） Video card maintenance summary - One, the black screen Clean: clean gold fingers with a rubber. The entire video card is clear. This is a necessary step. Inspection: carefully check the front and back of the video card, whether there is the virtual welding of components, damage and disengagement, whether the signal wiring is broken and distorted. Detection: check the power supply field effect tube of the card with multimeter, and the control of the control electrode of the field effect tube. The graphics card controls the chips power supply components. 4. Electric measurement voltage: whether the power supply point voltage of the power supply station, the control chip, the BIOS chip, the memory chip, the video card chip, and the power supply point of the power supply point is normal. 5 clock: A: whether the clock signal of the motherboard AGP slot is sent to the video card. B: whether the gold vibration on the video card is normal, and whether the laminar capacitor and the resistance are normal. 6 reset: A: whether the reset signal of the motherboard AGP slot is sent to the video card. B: the BIOS chip on the card. 7 field signal: whether the signal on the graphics card is normal output. This is the 13 or 14 pins of the VGA interface to see if the resistors are the same. Whether the output voltage of the feet is the same. Video memory: memory damage can also be black screen. To make a good or bad judgment, you can block each foot against the ground, and you can touch whether the memory is hot or not And so on. Main chip: the first 8 items are normal and only the main chip is broken. So much for maintenance. The main thing is that it doesnt make much sense. Second, the flower screen 1 DOS screen: add welding VGA pin, add welding VGA, add welding BIOS chip, add welding memory, can be eliminated basically. For the more serious screen, the welding doesnt work, the possibility of the damage is the most, and the bad development. If