p1007（p1007）.docVIP

p1007（p1007） I dont know much about other places, but there are not a few companies on our side. Im going to talk about it here, because I dont have a picture. In fact, 1008 plus powder is much simpler than 1020. It is noted that the two ends of the drum are not the previous structure, so it is easy to slide with a drum in the other hand with a drum in the other hand. Clean up the original powder Must be thoroughly cleared a 36 drums and 12 a different out 12 a mixed with big deal To add a 36 no Once mixed with Even the most clear also of no help You dont have to change the chip 1008 USES chemical carbon powder instead of traditional carbon powder Hpe 388a/CB436A cartridges are the toner cartridges used in HPs latest model products, which are provided below to illustrate the toner cartridges. Then slide the powder barn and the drum to the right to separate the powder barn from the drum. Carefully take down the drum core and the charging roller, be careful not to scrape the drum core! Then twist the screw on both sides of the waste powder barn to remove the scraper and clean up the waste powder. I think everyone is familiar with it! After cleaning the waste powder, install the scraper and fix the screws on both sides. Also pay attention to the sealing pad on both sides to prevent the leakage of powder! Clean the contact terminals on both sides of the charging roller. If the condition is coated with conductive silicone grease, then install the charging roller. Reinstall the cartridges to go back to the core, and suggest a carbon powder on the surface of the scraper or drum. Remove the fixed screw on the right side of the silos and notice that the screws have lock washer. Remove the two gears from the powder bin, keep the large spiral gear in place, remove the silos, and prepare to clean the powder barn and add powder. After cleaning the powder bin, you can add the powder. The sealing pad has the conditions to be replaced, and no conditions are not to be opened First,