特种设备习题（Special equipment problem sets）.doc

特种设备习题（Special equipment problem sets） Single option 1. At least two separate water level tables shall be installed for boilers that are rated as larger than (B) t/h. P137 A. 0.1 B. 0.2 C. 0.5 D. 1.0 2. Pressure gauge on boiler pressure vessel, dial diameter should not be less than (C) mm. P137 150 A. 120 B. 100 C. D. 50 4. The support ground for the special motor vehicles in the inspection field (factory) should be flat. Solid, should not be inspected in the underground building. The slope of the ramp shall not exceed (C) % P173 3 A. 5 B. 10 C. 15 D. 5. When the temperature of the metal wall of pressure vessel shell and the component below (B) ℃, as defined by the minimum temperature should be the design temperature. P113 A. - 30 B. - 20 C. - 10 D. 0 6. Pressure gauges commonly used in pressure vessels are (A) pressure gauges. P139 A. Elastic element B. liquid column C. the piston D. power 7. All the operating points of the crane which are not lower than (C) m shall be protected. P161 1 A. B. 1.5 2 C. D. 2.5 8. When the elevator car or the bottom of the squat, the device that absorbs the car and the heavy kinetic energy is called (D). A. safety gear B. speed limiter C. Limit switch D. buffer 9. No contact with the workpiece during the detection can not only detect the damage, but also reveal the dimensional change and the material characteristics of the detection method is (D). P153 A. magnetic memory detection B. magnetic particle detection C. Penetration detection D. Eddy current testing 10. According to our country existing function division, included in the scope of safety supervision of quality and technical supervision department of the hoisting machinery including rated lifting weight is greater than or equal to 1 t. and hoisting height is greater than or equal to (B) m crane. P111 1 A. 2 B. 3 C. 4 D. 11. The minimum distance between the crane and other equipment or fixed building should be kept at (A) above m. P160 A. 0.5 B. 1.0 C. 1.5 D. 2.0 12. Safety dev