现浇混凝土及钢筋混凝土模板工程量（Concrete and reinforced concrete template works）.doc

下载文档 降价啦

3
0
约1.5万字
约 13页
2017-08-04 发布于河南
举报
版权申诉
保障服务

现浇混凝土及钢筋混凝土模板工程量（Concrete and reinforced concrete template works）.doc

1、本文档共13页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

现浇混凝土及钢筋混凝土模板工程量（Concrete and reinforced concrete template works） It depends on the local quota, too much content. The following are the following: 1. The amount of concrete and concrete template works is calculated according to the following rules: 1. The amount of concrete and reinforced concrete template works shall be calculated in square meters except for the other regulations. If the contact area of the template is calculated using the modulus of modulus, the amount of engineering is equal to the volume of the component (the modulus of the module is included in the appendix). 2, single span reinforced concrete wall, board area of holes within 0.3 , shall not be deducted, dont add another hole in the wall template, but it outstand the wall of the lateral wall template shall be increased accordingly. Single-hole area outside the 0.3  holes, shall be deducted, hole wall template area into a wall, plate calculation within a template of quantities. 3, cast-in-situ reinforced concrete frame respectively according to the relevant provisions of the column, beam, wall, board, single column into the attached wall wall calculation of quantities on the wall, double wall column by column calculation, but after the amount of water wall, plate belt is not deducted. 4. The equipment bolt holes or equipment bolts shall be calculated according to different depth at different depths. The second grouting is calculated according to the volume of solid irrigation. 5. Precast concrete panel or edge patch with a width of 100mm, the template shall be calculated according to the plate quota. 6. The outer surface of the constructional column should be calculated according to the surface of the exposed section (the zigzag shape, the width of the width of the template is calculated according to the width of the blade). The surface area of the construction column shall not be calculated. 7, cast-in-situ concrete awning, balcony, horizontal cantilever slab, according to the size of this p