烟叶保管方法（Tobacco control method）.docVIP

烟叶保管方法（Tobacco control method） Storage and storage of tobacco leaves 4 tobacco warehouse and its requirements 4.1 address selection The tobacco warehouse should be set in low water table, high ground, good ventilation, smooth drainage, convenient transportation and no pollution around Place. 4.2 construction requirements 4.2.1 floor Should be above 0.5 m above ground, and laid moisture-proof layer. 4.2.2 wall Reinforced concrete structures are usually used. 4.2.3 doors and Windows The structure should be tight and flexible. Install screen window with aperture less than 1 mm, install wind curtain machine on door. 4.2.4 storetop The roof should be insulated. 4.2.5 wind tunnel The ventilation hole should be located at the floor of the ground floor 0.3 m ~ o. 4 m, with the insert board on the inside of the wall for the switch, the external wall installation aperture shall be less than 1mm screen window. The size of the wind tunnel is (o. 35 m ~ o. 40 m) x (0.15 m ~ o. 20 m). The area of the wind tunnel is compared with the area of the warehouse 1: (125 ~ 150). 4.2.6 cooling and dehumidifying equipment Warehouse should be set fan, QuShiJi, etc., the rolls temperature above 35 ℃ in the warehouse should be installed air conditioning. 4.2.7 fire protection requirements Firefighting facilities should be provided according to GB 50016 and the warehouse fire safety management rules. 5 tobacco use 5.1 The preparation of the leaves before entering the warehouse 5.1.1 warehouse health Before entering the warehouse, the tobacco leaf should clean the warehouse, remove cobwebs, garbage, debris, and smoke, and clog the holes, and use the protective agent to empty the warehouse and warehouse Disinfection. 5.1.2 cargo space planning Each warehouse should be divided into the cargo space and the number of the goods. The position of the position is underlined with color, 0.5m from the wall, 0.3m and stacking distance 0.5 2 M, the light distance is 0.5 m, the top is 0.5 m, and the main wal