华测rtk使用步骤（The use of RTK in China）.doc

华测rtk使用步骤（The use of RTK in China） Procedures and precautions for the use of RTK in China 1. Erection of base station, (precautions) : 1. The base station is as high as possible in the open area, and there is no high pressure line in the vicinity, and wireless signal tower such as mobile unicom. 2. The main engine of the base station tries to keep the distance of 3 meters above the top of the high-gain antenna to prevent the interference of GPS signals and radio signals. 3. Ensure that the joints of each connector are tightened and connected in the correct order, and finally connect the battery with the power cord of the battery, and must be guaranteed (red, black and negative). Note: at the end of the connection, the battery is in negative terminal and the power cord is first removed during the closing time. 4. If you encounter a rainy day or a hot sun, you should use soft bags and other items to cover the battery of the battery and the radio station to extend the life of the radio and battery. Go back to your unit every night and remember to recharge your batteries to ensure your homework tomorrow. Ii. Use of the base station There are two methods for setting up the base station. One is to set up a known point, and one is to set up at an unknown point, which is an arbitrary stand. 1. The common reference station adopts the self-priming. The advantage of this is that the base station can stand on any stand, but it should be set up in the open and high ground, generally using the roof of the houses, the top of the mountain and so on. 2. If it is set up in unknown points: set up instrument, open radio first, and then open the benchmark station host, wait until the base station on the host panel 3 a green light flashing, as well as the radio in the flashing a red light a second, since the launch of benchmark station host said success, benchmark stood in transmitting. If two or three minutes later, neither of these lights will flash, you can restart the main engine and