固定翼的起飞,降落方法及心得（Fixed wing take-off, landing methods and tips）.doc

固定翼的起飞,降落方法及心得（Fixed wing take-off, landing methods and tips） All fixed wing take-off, landing methods and tips! With the normal flight video, feel good you go to the top, Tags: dragon This post was finally edited by yulong 2011-4-12 19:54 This is attached to the normal flight video, full take-off and landing! The tail pushes k-8 trainer CAP232 smoking special effects machine This is the fixed wing flight control method that the younger brother has been summarizing for several years. I hope that I can help the novice, and I will not be unworthy of my afternoon keyboard beating life Some of them may be boring, but its really helpful for beginners, at least not to worry about how to take off and get damaged Foreword: airplane first flight method! It is recommended that the first flight should be carried out with a high hand throwing method. To avoid the loss of stall or crash! (except for large aircraft) Preparations for the first flight of all aircraft: 1: need to perform a high speed skating test (avoid ground or twist gear after take-off and landing, and there is no need to test at low speed) 2: hold the aircraft for a static full throttle test for 1-2 minutes. The main purpose is to check whether the electric tuning will overload (the air current is overloaded) and the motor seat is not Its fixed. 3: all the channels are fine-tuned, the aircrafts various rudder surfaces are manually adjusted to the standard position, and the purpose is clear Or dive or roll? 4: check the working conditions of the various channels and see if the steering gear has a reverse course (I have had such a loss) 5: check whether the rudder and steering wheel are on the same horizontal line. To raise a very simple question, if the reverse rudder and the steering wheel are not parallel, turn the machine wheel on the ground At a level, the rudder would be tilted to one side, and then there would be a yaw. After liftoff, you can see that the rudder is not parallel and the rudder is debugged As