命题考点九 《地下防水工程质量验收规范》中的相关规定（The relevant provisions in the quality acceptance criterion of underground waterproof works）.docVIP

命题考点九 《地下防水工程质量验收规范》中的相关规定（The relevant provisions in the quality acceptance criterion of underground waterproof works） 1 a430000 construction engineering regulations and related knowledge 1 a430,000 construction engineering regulations and related knowledge section exercise online test The relevant provisions in the quality acceptance criterion of underground waterproof works [textbook interpretation] I. underground construction waterproof project 1. The materials and proportion of waterproof concrete shall meet the following requirements (1) the cement variety shall be chosen according to the design requirements, and the strength level shall not be lower than 32.5; The amount of cement shall not be less than 300kg/m3, the amount of cement shall not be less than 280kg/m3 when mixed with the activity. The water cement ratio must not be greater than 0.55. (2) the particle size of gravel or pebbles should be 5 ~ 40mm, the content of mud content should not be more than 1.0%, and the content of mud block should not be greater than 0.5%; Sand should be used in sand, and the content of mud should not be more than 3.0%, and the content of mud should not be more than 1.0%; The sand ratio should be 35 % ~ 45 %, and the sand ratio should be 1:2 ~ 1:2. 5. (3) the grade of fly ash should not be lower than the secondary level, and the amount should not be more than 20%; The amount of silica powder should not exceed 3%. (4) the anti-seepage pressure value should be 0.2mpa higher than the design value. (5) the ordinary waterproof concrete slump should not be greater than 50mm, and the slump of the pump in the pump should be 100 ~ 140mm. 2. The materials for the cement mortar waterproof layer shall meet the following requirements (1) the cement variety shall be selected according to the design requirements, and the strength grade shall not be lower than 32.5. (2) sand should be used in sand, with a particle size of 3mm, and the content of mud content should not be greater than 1%,