命题考点十三 建筑工程屋面及装饰装修工程的相关标准（The relevant standards of the building and decoration of the construction project）.docVIP

命题考点十三 建筑工程屋面及装饰装修工程的相关标准（The relevant standards of the building and decoration of the construction project） 1 a430000 construction engineering regulations and related knowledge 1 a430,000 construction engineering regulations and related knowledge section exercise online test The relevant standards of the building and decoration of the construction project [textbook interpretation] I. relevant provisions of the inspection and acceptance specification for roofing engineering 1. Waterproofing roofing project (1) when the base of the leveling layer adopts the assembly type reinforced concrete slab, the following provisions shall be met: 1) the slabs of fine stone concrete can be applied to the plate and side seam, and the strength level should not be lower than that of C20; 2) when the width of the slabs is larger than 40mm or wider, the structural steel reinforcement shall be installed in the seam. 3) the plate end seam should be sealed. (2) the drainage slope of the roof (including the ditch and gutter) has to meet the design requirements. The slope should not be less than 3 % and the slope should be 22. The vertical slope of the gutter and gutter should not be less than 1%, and the bottom of the ditch should be lower No more than 200mm. (3) the insulation layer should be dry, and the moisture content of the enclosed insulation layer should be equal to the equilibrium moisture content of the material in the local natural air drying state. Exhaust measures should be adopted when the roof insulation layer is dry and difficult. (4) the moisture content of the insulation layer must meet the design requirements. (5) the direction of the roll should meet the following requirements: 1) when the roof slope is less than 3%, the roll shall be covered with parallel roof. 2) when the roof slope is 3 % ~ 5 %, the roller can be parallel or vertical roof. 3) roof slope is more than 15%, or roof by vibration, asphalt waterproof coiled material should be perpendicular to the roof of